Pelles C forum
C language => Beginner questions => Topic started by: kejster on October 08, 2021, 06:10:34 PM
-
I have been playing around with Pelles C for a while now, and I really like it.
One thing that I haven't been able to figure out, though, is if it's possible to show the "Project" tab instead of "Output" after a build.
When I get compiler errors (which happens a lot, since my C is very rusty :-)), the Output tab will say "Project build ended in complete failure".
Then, I will have to switch to the "Project" tab to see what went wrong.
Is there some setting to just have the "Project" tab show after the build?
Best regards.
Kenneth.
-
Try this: "Tools" -> "Customize..." -> "Add-ins" tab, uncheck "Show IDE events", and the click "OK".
-
Try this: "Tools" -> "Customize..." -> "Add-ins" tab, uncheck "Show IDE events", and the click "OK".
Once again Pelle, please is possible to avoid to load and enable all addins on the installation of a new version?
Can't you use just those already set in the registry?
Thanks
-
Try this: "Tools" -> "Customize..." -> "Add-ins" tab, uncheck "Show IDE events", and the click "OK".
Thank you. That did the trick!
Best regards.
Kenneth.
-
Thank you. That did the trick!
Very good, thanks!
-
Once again Pelle, please is possible to avoid to load and enable all addins on the installation of a new version?
Can't you use just those already set in the registry?
Nothing there to use for a fresh install, and much more convenient when the IDE defaults to enabled state for new add-ins.