NO

Author Topic: Problem with assigning shortcut.  (Read 2501 times)

rxantos

  • Guest
Problem with assigning shortcut.
« on: January 25, 2012, 09:09:30 pm »
After assigning CTRL-H as a keystroke to show the replace dialog. The replace dialog is also shown when the backspace is pressed.

My guess is that CTRL-H and Backspace have the same ASCII code. This is confirmed by Assigning CTRL-M to show the replace Dialog, since it has the same ASCII code as ENTER, the replace dialog is shown every time ones presses enter.


PellesC IDE 6.50, 64 bit.

CommonTater

  • Guest
Re: Problem with assigning shortcut.
« Reply #1 on: January 25, 2012, 09:25:54 pm »
CTRL-H is indeed backspace.   You can use Shift+H or Shift-Ctrl-H etc.




Offline AlexN

  • Global Moderator
  • Member
  • *****
  • Posts: 392
    • Alex's Link Sammlung
Re: Problem with assigning shortcut.
« Reply #2 on: January 26, 2012, 01:02:26 pm »
CTRL-H is indeed backspace.   You can use Shift+H or Shift-Ctrl-H etc.
I think Shift+H is also a not so good idea. How will you write "H". ;)
But I think you can also you a combination with the ALT-key.
best regards
 Alex ;)

CommonTater

  • Guest
Re: Problem with assigning shortcut.
« Reply #3 on: January 26, 2012, 03:13:22 pm »
CTRL-H is indeed backspace.   You can use Shift+H or Shift-Ctrl-H etc.
I think Shift+H is also a not so good idea. How will you write "H". ;)
But I think you can also you a combination with the ALT-key.

:D ...  That's no problem .... You don't need capital H anywhere in C  .... :D

The Alt key is sounding like a real good idea....